Filament spool holder for Makerbot ToM

A couple of simple parts to hold the spool over the ToM.

The feet that fit the holes in the top of a ToM with some space to feed cables through. Mirror them so that you have at least one with the opening on the left and one on the right. The other two don't matter as there aren't any cables comes out the holes where the fit in.

nh800 (OpenSCAD) nh800 (stl)

The top corners.

nh601d (OpenSCAD) nh601d (stl)

I've printed the parts with different fill settings: 0, 30 and 50. All seem ok, the horizontal holes weren't completely round: 

1. there was some warping, which caused the holes to be too small - printed again with less warping,
2. the top of the horizontal holes is tricky as it printed these along the axis, in free space, they work fine after a bit of cleanup.

As you can see in the pictures you'll need four feet and two corners.

Cut some pvc tubing to the right length, i've used something like 4x 17cm and 1x 32cm (should be at least 27cm). Done! 

Some additional pictures:

Get OpenSCAD from www.OpenSCAD.org
Printed from replicatorg-0029_r2 on linux (just saw 0031 was released today)